pyrolysis plant

How to extraction copper from copper wire stripping machine?

2017-08-26 14:18:00 Pyrolysis Plant Auxiliary Equipment
how to extraction copper
Copper wire stripping machine
We can throw waste copper wire into copper wire stripping machine at one time, after crush processing. Dry type copper meters machine’s dedicated shaker equipment mechanical separation. Thorough separate to copper and plastic, also reach aim of complex utilization. Without dust and second pollution, and have higher recycling economic effectiveness, and have fast deal with recycling of copper / plastic way.
The whole production line has unique structure, big process capacity and low power consumption. With high separation rate, the separation is conducted by several parts. This copper wire stripping machine has not only improved the purity of copper, but also reduced the pollution to the environment.

How to extraction copper from copper wire stripping machine?


wire stripping machine
Wire stripping machine working process
1. Starting
Please make sure waste wire stripping machine and another equipments are in good condition. Then start the machine, and keep the machine running unloaded for 5-10 minutes before feeding.
Attention:
Boot sequence: suction fan1→suction fan 2→blower-feeding blower →riddler→mainframe.
Shutdown sequence: Riddler→blower→suction fan1→suction fan
2→feeding blower→mainframe

2. Feeding
Before feeding, pick up the debris especially the iron from the wires in case of the damage to the crusher blades. During the feeding period, the feeding speed should be in accordance with the crushing speed.

3. Fine crushing
If there is any abnormal noise, please stop and check the crusher, or change different size screen.
If there is too much copper or the produced particles are relatively small during the production process, replace the screen and adjust the distance between the fixed knife and the moving one.

If the machine is easy to overheat, stop the device and inspect the gearing.

4.Vibrating separator
After crushed, the mixed material will be delivered to vibrating device. The copper from vibrating separator is complete copper without plastic, while the copper clad from the opposite discharging hole needs the second crushing.





Leave A Message About Auxiliary Equipment

Send message
TOP